Spilt curve tool

bunnyb · Post by **bunnyb** » Wed Jul 11, 2007 5:46 am

Hi,
I am using the split curve tool quite a lot at the moment,
but not all of the added points seem to have the same vector modifier ie smooth or peak.
Is there any way to force them to be one or the other?
Regards

funksmaname · Post by **funksmaname** » Wed Jul 11, 2007 7:11 am

while the points are selected, press 'p' for sharp points or 'm' for smooth points... i use p/m almost exclusively over the curature tool...

bunnyb · Post by **bunnyb** » Wed Jul 11, 2007 10:58 pm

thanks funksmaname,
Didnt know you could do that!
Regards