Ant walking

patricia3d · Post by **patricia3d** » Sat Jan 02, 2010 11:06 am

Work in Progress.
Ant created in Anime Studio Pro 6.1

Hope every one will like it.

slowtiger · Post by **slowtiger** » Sat Jan 02, 2010 2:52 pm

Very nice!

Now let's move it ... Are you going to use these as particles?

patricia3d · Post by **patricia3d** » Sat Jan 02, 2010 5:12 pm

Thanks Slowtiger for your comments. 1st I will rig it and try to make it walk. If I don't get success, then I will try to use as particles.

Post by **Víctor Paredes** » Sat Jan 02, 2010 5:43 pm

kkrawal wrote:Thanks Slowtiger for your comments. 1st I will rig it and try to make it walk. If I don't get success, then I will try to use as particles.

You can animate a walkcycle and put that rig inside a particle later. Bones and particles aren't exclusive.

patricia3d · Post by **patricia3d** » Sat Jan 02, 2010 6:21 pm

Thanks Selgin for your comments. Its a good idea. It will be like the Hen Particles given with 6.1.

patricia3d · Post by **patricia3d** » Sun Jan 03, 2010 6:32 pm

I have modified some part of the ant

and walk 120 is here
http://patricia3d.webs.com/ant41.swf

Please give your idea.

patricia3d · Post by **patricia3d** » Mon Jan 04, 2010 5:45 pm

Some More Developments.
Please see in HQ Mode.

http://www.youtube.com/watch?v=CsSaK6hR2wM

Genete · Post by **Genete** » Mon Jan 04, 2010 11:47 pm

Make a six leg walking cycle is quite complicated. Also make it turn is even more complicated.
The design is fine (I would change the eyes into other type) but I think that they should walk faster. Also some antenna movement and some stop/runs would work too.

Good luck with the challenge

-G

patricia3d · Post by **patricia3d** » Tue Jan 05, 2010 5:09 am

Thanks for guidance. I will do these changes and show again.