Moho Forum

Hello everyone,

I'm a newbie to Moho -- it's the greatest animation tool I have found.

When building my characters, it appears that the outline is a little thinker than I care for. I usually have it set for 1. Is there a way to get a value less than 1? I.E. 0.5 or 0.75, etc.

All the best,



Phil

1 is the smallest value for line width you can use. However, if you turn off "Scale compensation" in the Layer Settings dialog for the vector layer in question, Moho will use a different algorithm to draw lines, resulting in a slightly thinner line.

You might also consider using a shade of gray, instead of black, to make a line appear thinner.

I noticed the line also looks thinner if you draw the object larger and then scale the layer smaller.

I will try all of your suggestions. Thanks for the help.