Page 1 of 1

Spilt curve tool

Posted: Wed Jul 11, 2007 1:46 pm
by bunnyb
Hi,
I am using the split curve tool quite a lot at the moment,
but not all of the added points seem to have the same vector modifier ie smooth or peak.
Is there any way to force them to be one or the other?
Regards

Posted: Wed Jul 11, 2007 3:11 pm
by funksmaname
while the points are selected, press 'p' for sharp points or 'm' for smooth points... i use p/m almost exclusively over the curature tool... :)

Posted: Thu Jul 12, 2007 6:58 am
by bunnyb
thanks funksmaname,
Didnt know you could do that!
Regards