Moho Animation Forum

Hi,
I have an issue where the bones of a bone layer don't show when I select a child vector layer of it. Normally they always show, so that when I use the layer bind tool, I can then select the bone to bind the vector layer to it.
When I create a new bone and vector layer inside the project, it works fine.
Is this a bug or is there a way I can fix this?


The bone layer settings:


The vector layer settings:

Right-click the bone layer, select quick settings, and enable Paths.

This is usually enabled for new bone layers.

synthsin75 wrote: ↑Fri Nov 21, 2025 6:08 pm Right-click the bone layer, select quick settings, and enable Paths.

This is usually enabled for new bone layers.

What a silly little oversight by me.
Thank you very much, synthsin!