Moho Animation Forum

Hi.

I'm following Victor's tutorial on Curvers. ( https://www.youtube.com/watch?v=99Pb5BQejcA ).
For a test I created a thick stick man and imported it into Moho. It's on a single layer.

I created a curver for one of the legs. It works fine but as soon as I get off frame one, the rest of the image disappears.

Am I going about this the wrong way?

Thanks.

Curvers work similar to a warp mesh, so they also mask the artwork. The easiest way to do it with a single image is to duplicate the image and make a curver for each part.

Thanks. that works.