Moho Forum

Please improve the mechanism of binding gradient color to bone weight~! Color nodes cannot completely replace the work of gradient color for the time being, please help

You just need to isolate that/those layers to the bones with the strength to cover the entire gradient. That way no other bone influence is competing to control the gradient.

synthsin75 wrote: ↑Tue Mar 04, 2025 4:47 am You just need to isolate that/those layers to the bones with the strength to cover the entire gradient. That way no other bone influence is competing to control the gradient.

Yes, I created a separate layer for this and fully wrapped the weight range around the shape, using the bone settings that only affect this layer. But the gradient color is still torn apart---- I seem to have raised a similar question before, and even uploaded a Moho file~~

It seems that there is a [square range], and as long as it exceeds this range, the gradient color will be wrong.

sang820 wrote: ↑Tue Mar 04, 2025 3:48 pm

These overlapping bone strengths are the likely problem.

synthsin75 wrote: ↑Wed Mar 05, 2025 1:57 am

sang820 wrote: ↑Tue Mar 04, 2025 3:48 pm

These overlapping bone strengths are the likely problem.

I deleted all the graphics and bones, leaving only a magnetic area, and after eliminating all these factors, I found that there seemed to be a problem with the liquid graphics. As long as it was not a liquid graphic, the gradient would not be broken.
I've attached the moho file of the demo video, let's figure this out together. I think this will be helpful for the development of liquid graphics.
https://drive.google.com/file/d/1Gs32ZD ... sp=sharing

Oh yeah, the liquid shape is having problems.

synthsin75 wrote: ↑Wed Mar 05, 2025 4:57 am Oh yeah, the liquid shape is having problems.

Looking forward to fixing it in the next minor version~