Moho Forum

Any ideas as to what I am doing wrong? I built a simple car in Lightwave 3D and exported the model with a logo on a door panel. I import into Moho and there is no logo on the model. The .mtl file says there is a logo there but there is no logo on the model??? Funny thing is...I have a similar that has two logo's on it that work fine. I made sure that the Logo images are in the same folder as the model. Any ideas as to what's happening?
Cheers
D.K

Here is the mtl file. The object should be looking for the 'logo" at the bottom.
Does anyone know how to read this? Where is it looking for the "logo"?
Cheers
DK


newmtl Default
Kd 0.501961 0.501961 0.501961
Ke 0 0 0
Ka 0 0 0
Ks 0.5 0.5 0.5
Ns 400
Tr 0
d 1
Ni 1.5
Tf 1 1 1

newmtl logo
Kd 0.501961 0.501961 0.501961
Ke 0 0 0
Ka 0 0 0
Ks 0.5 0.5 0.5
Ns 400
Tr 0
d 1
Ni 1.5
Tf 1 1 1

If there are image textures, they would be referenced with map statements map_XX - like:

map_Ka myimage.jpg

Thank you so much for the info SimpleSam. I did a workaround by turning an image panel into a replica of a polygon and set it in the correct 3D space so it lay over the polygon that has no image. There must be something wrong with my 3D Software
Cheers
D.K