Moho Forum

Hello folks
I think Moho Virgen 13.5.3 has a problem cos I can't scale pin Bone by clicking Ctrl + L_mouse
instead of scaling the bone, it moves with the mouse mark.

Are you on an animation frame (1+)? You can't scale a Pin bone on frame 0.

Also, scaling is done using Ctrl+RMB, not Ctrl+LMB.

Hope this helps.

Greenlaw wrote: ↑Fri Apr 22, 2022 2:05 am Are you on an animation frame (1+)? You can't scale a Pin bone on frame 0.

Also, scaling is done using Ctrl+RMB, not Ctrl+LMB.

Hope this helps.

yeah, it was helpful thank you