Moho Forum

Hello Forum,

I just bought Moho. I wasn't exactly sure where to post this sort of question on the forum, please point in the right direction if this isn't correct.

I was following the tutorials and learning the layout when I noticed that my Layer Settings are missing the Masking and Physics tabs. I'm including a screen shot of my Layers and Layer Settings. My layers are vector layers and shapes. I have Moho 13.5

Guidance and some direction would be wonderful!

Thank you in advanced!

Please make a smaller signature.


Masking and physics are only available after being enabled in the parent layer.

You can now right click on the folder for pants & body and select 'Mask - Inside Bottom Layer' or 'Mask - Outside Bottom Layer' then you'll see your masking settings.

Thank you both!