Page 1 of 1

Am I the only one who can´t "lower shape" anymore?

Posted: Thu Dec 15, 2005 4:02 pm
by kasjorg
I don´t get it............ after I installed version 5.3 the "lower shape" button has moved to the bottom of my toolbar under "other" tools and it doesn´t seem to work!! Is there any good reason for this or am I doing something wrong?????

Posted: Thu Dec 15, 2005 4:29 pm
by Toontoonz
Works for me from the fill section:
Click on shape with Shape Select tool.
Click on raise and lower shape buttons.

If you have lots of shapes it could be you have to click it several times to notice it moving up or down through the layers of shapes.

Posted: Thu Dec 15, 2005 5:06 pm
by Rasheed
I have this showing in my tool window:
Image

The lower and raise shape tools belong in the Fill section, not in the Other section. Perhaps you should contact LM if the lower and raise shape tools are located elsewhere in your copy of Moho v5.3.1, because something has gone wrong there.

Posted: Thu Dec 15, 2005 5:51 pm
by Toontoonz
It´s in the "Other" tools section! Wow! How did that happen? Sounds like a bug - what type computer are you using?

Posted: Thu Dec 15, 2005 9:03 pm
by Lost Marble
Have you added any custom tools to your toolbar, or edited the "_tool_list.txt" file?

Posted: Fri Dec 16, 2005 8:17 am
by kasjorg
Yes I have changed some hotkeys for workspace tools in the "_tool_list.txt" file , would that affect the "lower shape" button.

Yes yes I didn´t have any problems before "lower shape" used to be in the shape toolbox and worked like a charm:)

Posted: Fri Dec 16, 2005 8:18 am
by kasjorg
Uh sorry the button was in the fill toolbox of course